Disassembly and assembly

Illustration 270 g02948516
2. Lubricate the bearing housing in the cylinder block
with clean engine oil.
3. Accurately align large oil Hole (X) in camshaft
bearing (1) with the oil hole in the cylinder block.
4. Use Tooling (A) and Tooling (B) in order to install
camshaft bearing (1) into the cylinder block.
Note: Ensure that the oil holes are correctly aligned.
If the oil is not correctly aligned, the camshaft bearing
should be removed.
End By:
a. Install the camshaft. Refer to Disassembly and
Assembly, “Camshaft - Remove and Install” for
the correct procedure.
i05279037
Engine Oil Pan - Remove and
Install
(Pressed Steel Oil Pan)
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Illustration 271 g02823478
1. Remove oil drain plug (6). Drain the engine oil into
a suitable container for storage or disposal.
2. Remove sealing washer (5) (not shown) from oil
drain plug (5).
3. Remove two M10 bolts (7) and remove M8 bolts
(3) from engine oil pan (4).
Note: Support the weight of the engine oil pan.
4. Remove spacer (2) from engine oil pan (4).
5. Remove engine oil pan (4) from the cylinder block.
6. Remove gasket (1) (not shown).
148 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE