Disassembly and assembly

7. Install Tooling (B). Refer to Disassembly and
Assembly, “Idler Gear - Remove” for the correct
procedure.
8. Install camshaft timing ring (2) onto dowels (5).
9. Install bolts (3) into camshaft (4). Tighten the bolts
to a torque of 25 N·m (221 lb in).
End By:
a. Install the idler gear. Refer to Disassembly and
Assembly, “Idler Gear - Install” for the correct
procedure.
b. Install the rocker shaft and pushrods. Refer to
Disassembly and Assembly, “Rocker Shaft and
Pushrod - Install” for the correct procedure.
i05279035
Camshaft Bearings - Remove
and Install
Removal Procedure
Table 56
Required Tools
Tool Part Number
Part Description Qty
A T400085
Camshaft Bushing Punch
Tool
1
B
T400084
Handle for Punch Tool 1
Start By:
a. Remove the camshaft. Refer to Disassembly
and Assembly, “Camshaft - Remove and
Install” for the correct procedure.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 269 g02729141
1. Inspect camshaft bearing (1). Refer to
Specifications, “Camshaft Bearings” for more
information.
2. If camshaft bearing (1) is worn or damaged, use
Tooling (A) and Tooling (B) in order to remove the
camshaft bearing from the cylinder block.
Note: Remove the camshaft bearing from the front of
the cylinder block.
Installation Procedure
Table 57
Required Tools
Tool Part Number
Part Description Qty
A T400085
Camshaft Bushing Punch
Tool
1
B
T400084
Handle for Punch Tool 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Clean the bearing housing in the cylinder block.
Ensure that the oil hole in the bearing housing is
free from debris.
UENR0624-03 147
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE