Disassembly and assembly

Illustration 265 g02945576
Illustration 266 g02945776
Illustration 267 g02945716
Illustration 268 g02945837
3. Lubricate the teeth of gear (1) with clean engine
oil.
4. Align the timing mark on camshaft (4) in Position
(V) with the timing mark on the front housing in
Position (W).
5. Position camshaft gear (1) onto camshaft (4).
Ensure that dowel (6) is installed into Hole (X) in
the camshaft.
6. Ensure that the chamfered tooth on the crankshaft
gear in Position (Y) is between the timing marks in
Positions (Z) on the camshaft gear.
146 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE