Disassembly and assembly

ManualsBrandsPerkins Engine ManualsOther854F-E34T, 854E-E34TA, 854F-E34TA Disassembly and Assembly

141

142

143

144

145

146

147

148

149

150

Turn Torx bolts (1) through 60 degrees.

17. Install the injectors. Refer to Disassembly and

Assembly, “Injector - Install” for the correct

procedure.

18. Install the glow plugs. Refer to Disassembly and

Assembly, “Glow Plugs - Remove and Install” for

the correct procedure.

19. Install the rocker shaft assembly and the

pushrods. Refer to Disassembly and Assembly

Manual, “Rocker Shaft and Pushrod - Remove” for

the correct procedure.

20. Install the exhaust manifold. Refer to

Disassembly and Assembly, “Exhaust Manifold -

Remove and Install” for the correct procedure.

21. If necessary, install the water temperature

regulator housing to the cylinder head. Refer to

Disassembly and Assembly, “Water Temperature

Regulator Housing - Remove and Install” for the

correct procedure.

22. Connect the upper radiator hose to the water

temperature regulator housing .

23. Fill the cooling system with coolant. Refer to

Operation and Maintenance Manual, “Cooling

System Coolant - Change” for the correct filling

procedure.

24. If necessary, fill the engine oil pan to the correct

level. Refer to Operation and Maintenance

Manual, “Engine Oil Level - Check”.

i05275402

Lifter Group - Remove and

Install

Removal Procedure

Table 52

Required Tools

Tool Part Number

Part Description Qty

Telescoping Magnet

Start By:

a. Remove the camshaft. Refer to Disassembly

and Assembly, “Camshaft - Remove and

Install” for the correct procedure.

NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened

component life.

Illustration 259 g02729121

1. If the crankshaft is installed, rotate the crankshaft

in order to gain access to the appropriate lifters.

2. Use Tooling (A) in order to remove lifters (1) from

the cylinder block.

Note: Place a temporary identification mark on each

lifter in order to identify the correct location.

Installation Procedure

Table 53