Disassembly and assembly

10. Install Torx bolts (1) and Torx bolts (2) to cylinder
head (3).
11. Remove Tooling (D).
12. Install remaining Torx bolts (1) to cylinder head
(3).
Illustration 256 g03005658
Sequence for tightening the bolts for the cylinder
head
13. Use Tooling (A) in order to tighten Torx bolts (2) to
a torque of 130 N·m (96 lb ft) in the sequence that
is shown in Illustration 256 .
14. Use Tooling (B) in order to tighten Torx bolt (1) to
a torque of 65 N·m (48 lb ft) in the sequence that
is shown in Illustration 256 .
Illustration 257 g03005916
15. Use Tooling (A), Tooling (B), and Tooling (C) in
order to turn Torx bolts (1) and Torx bolts (2)
through an additional angle in the sequence that is
shown in Illustration 256 .
Turn Torx bolts (2) through 90 degrees.
Turn Torx bolts (1) through 90 degrees.
Illustration 258 g03017298
16. Use Tooling (A), Tooling (B), and Tooling (C) in
order to turn Torx bolts (1) and Torx bolts (2)
through an additional angle in the sequence that is
shown in Illustration 256 .
Turn Torx bolts (2) through 70 degrees.
UENR0624-03 141
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE