Disassembly and assembly

Illustration 253 g03005660
6. Use a suitable lifting device to lift the cylinder
head. The weight of the cylinder head is
approximately 30 kg (66 lb).
Note: Use a spreader bar during the lifting operation
in order to distribute the weight of the cylinder head.
7. Use Tooling (D) to align cylinder head (3) with the
cylinder block. Install the cylinder head to the
cylinder block.
Note: Ensure that the cylinder head is correctly
positioned onto dowels.
Illustration 254 g03005656
Illustration 255 g03005937
8. Clean Torx bolts (1) and Torx bolts (2). Follow
Steps 8.a and 8.b for the procedure to inspect the
Torx bolts.
a. Check the length of the Torx bolts (1) and Torx
bolts (2).
b. Use Tooling (E) in order to check the threads of
the Torx bolts. Refer to Illustration 255 . Replace
any Torx bolts that show visual reduction in the
diameter of the thread over length (Y).
9. Lubricate the threads and the shoulder of Torx
bolts (1) and Torx bolts (2) with clean engine oil.
140 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE