Disassembly and assembly

NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorized personnel that have the correct
training.
Before beginning ANY work on the fuel system,
refer to Operation and Maintenance Manual,
“General Hazard Information and High Pressure
Fuel Lines” for safety information.
Refer to System Operation, Testing and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
1. Turn the battery disconnect switch to the OFF
position.
2. Turn the fuel supply to the OFF position.
3. Drain the secondary filter. Refer to Operation and
Maintenance Manual, “Fuel System Secondary
Filter - Replace” for the correct procedure.
Illustration 20 g03011036
4. Make temporary identification marks on plastic
tube assembly (1) and plastic tube assembly (2) in
order to show the correct position of the plastic
tube assemblies.
5. Place a suitable container below the fuel filter base
in order to catch any fuel that might be spilled.
6. Disconnect plastic tube assembly (1) and plastic
tube assembly (2) from fuel filter base (3).
7. Use Tooling (A) in order to plug plastic tube
assembly (1) and plastic tube assembly (2)
8. Use Tooling (A) in order to cap the connection on
fuel filter base (3).
9. Slide locking tab in to the unlock position.
Disconnect harness assembly (5) from fuel
temperature sensor (4).
14 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE