Disassembly and assembly

Illustration 251 g03005663
7. Remove cylinder head gasket (4).
8. Note the position of dowel (5) and dowel (6) in the
cylinder block. Do not remove the dowels unless
the dowels are damaged.
9. If necessary, remove the water temperature
regulator from the cylinder head. Refer to
Disassembly and Assembly, “Water Temperature
Regulator - Remove and Install”.
i05275401
Cylinder Head - Install
Installation Procedure
Table 51
Required Tools
Tool
Part Number
Part Description Qty
A
-
E14 Torx 1/2 Inch Drive
Socket
1
B
27610299
E18 Torx 1/2 Inch Drive
Socket
1
C 27610289
Angle Gauge
1
D
-
Guide Bolt
(M12 by 115mm)
1
E
-
Straight Edge
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Thoroughly clean the gasket surfaces of the
cylinder head and the cylinder block. Do not
damage the gasket surfaces of the cylinder head
or the cylinder block. Ensure that no debris enters
the cylinder bores, the coolant passages, or the
lubricant passages.
2. Inspect the gasket surface of the cylinder head for
distortion. Refer to Specifications, “Cylinder Head”
for more information.
Illustration 252 g03005897
Typical example
3. Inspect dowel (5) and dowel (6) for damage. If
necessary, replace the dowels in the cylinder
block.
4. Install Tooling (D) to the cylinder block. Refer to
Illustration 252 .
5. Align cylinder head gasket (4) with Tooling (D) and
with dowel (5) and dowel (6). Install the cylinder
head gasket onto the cylinder block.
UENR0624-03 139
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE