Disassembly and assembly

End By:
a. Install the valve mechanism cover. Refer to
Disassembly and Assembly, “Valve
Mechanism Cover - Remove and Install” for the
correct procedure.
i05275396
Cylinder Head - Remove
Removal Procedure
Table 50
Required Tools
Tool Part Number
Part Description Qty
A
-
E14 Torx 1/2 Inch Drive
Socket
1
B
27610299
E18 Torx 1/2 Inch Drive
Socket
1
Start By:
a. Remove the exhaust manifold. Refer to
Disassembly and Assembly, “Exhaust
Manifold - Remove and Install”.
b. Remove the injectors. Refer to Disassembly
and Assembly, “Injector - Remove”.
c. Remove the rocker shaft assembly and the
pushrods. Refer to Disassembly and Assembly
Manual, “Rocker Shaft and Pushrod - Remove”.
d. Remove the glow plugs. Refer to Disassembly
and Assembly, “Glow Plugs - Remove and
Install”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Note: Put identification marks on all hoses, on all
hose assemblies, on wires and on all tube
assemblies for installation purposes. Plug all hose
assemblies and tube assemblies. Plugging all hose
assemblies helps to prevent fluid loss and helps to
keep contaminants from entering the system.
1. Drain the coolant from the cooling system into a
suitable container for storage or for disposal. Refer
to Operation and Maintenance Manual, “Cooling
System Coolant - Change” for the correct draining
procedure.
2. Disconnect the upper radiator hose from the water
temperature regulator housing.
Illustration 248 g03005656
Typical example
UENR0624-03 137
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE