Disassembly and assembly

b. Remove O-ring seal (3) from plug (4).
c. Install Tooling (A) into the cylinder block in
Position (Z).
Note: Tooling (A) must be located in Hole (Y) in the
crankshaft.
Note: Ensure that Tooling (A) is located in the
correct drilling in the crankshaft as shown in
Illustration 240 .
Illustration 241 g02942696
Illustration 242 g02942756
2. Remove bolts (6) from rocker shaft (4) in the
reverse numerical sequence shown in Illustration
242 .
3. Remove rocker shaft (4) from the cylinder head.
4. Make temporary identification marks on push rods
(5). Remove the push rods from the cylinder head.
5. Remove wear caps (3) from the valve stems.
Identify the position of the wear caps in order for
the wear caps to be installed in the original
location.
UENR0624-03 133
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE