Disassembly and assembly

Illustration 235 g03010838
Typical example
8. Remove gasket (9) from valve mechanism cover
(2).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 236 g03010838
Typical example
1. Thoroughly clean all gasket surfaces of valve
mechanism cover (2). Clean the gasket surfaces
of the cylinder head.
2. Install a new gasket (9) to valve mechanism cover
(2).
Note: Ensure that the gasket is fully seated into the
groove of the valve mechanism cover.
Illustration 237 g03010836
Typical example
Illustration 238 g02671296
3. Position valve mechanism cover (2) onto the
cylinder head.
4. Install bolts (7) and bolt (8) to the valve mechanism
cover.
5. Tighten the bolts in the numerical sequence that is
shown in Illustration 238 .
UENR0624-03 131
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE