Disassembly and assembly

8. Ensure that there is tactile backlash between the
idler gear and the accessory drive gear.
9. If necessary, install the OEM driven equipment to
accessory drive (4). Refer to the OEM for the
correct procedure.
10. If the OEM driven equipment was not installed
onto accessory drive (4), position new gasket (3)
(not shown) and cover plate (2) onto accessory
drive (4).
11. Install bolts (1) to cover plate (2). Tighten the
bolts to a torque of 25 N·m (221 lb in).
i05270847
Crankcase Breather - Remove
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Table 45
Required Tools
Tool Part Number
Part Description Qty
A
-
1/2 Inch Drive x 19
mm Hex Drive
1
Illustration 231 g02689857
1. Disconnect hose (8) from crankcase breather
cover (11).
2. If necessary, disconnect hose (9) from crankcase
breather cover (11).
3. Remove nuts (10) from studs (12).
4. Remove crankcase breather cover (11) from front
cover (1). Remove O-ring (7) from the crankcase
breather cover.
5. Remove circlip (6) from spigot (3).
6. Remove breather element (5) from spigot (3).
7. If necessary, use Tooling (A) in order to remove
threaded insert (4) and spigot (3) from fuel
injection pump shaft (2).
8. If necessary, remove studs (12) from front cover
(1).
i05270850
Crankcase Breather - Install
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
128 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE