Disassembly and assembly

a. Install new O-ring seal (10) to cover plate (8).
Apply Tooling (D) to O-ring seal (10).
b. Install cover plate (8) to the front housing.
c. Install bolts (9) to the cover plate and tighten the
bolts to a torque of 25 N·m (221 lb in).
19. If necessary, install the fan drive. Refer to
Disassembly and Assembly, “Fan Drive - Remove
and Install” for the correct procedure.
End By:
a. Fill the cooling system with coolant. Refer to
Operation and Maintenance Manual, “Cooling
System Coolant - Fill” for the correct
procedure.
i05270844
Accessory Drive - Remove and
Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Illustration 227 g02898881
Illustration 228 g02898938
1. If necessary, remove the Original Equipment
Manufacturer's (OEM) driven equipment from
accessory drive (4). Refer to the OEM for the
correct procedure.
2. If the OEM driven equipment was not installed onto
accessory drive (4). Remove cover plate (2) and
remove gasket (3) (not shown).
3. Remove Allen head bolts (6) from accessory drive
(4). Remove the accessory drive housing from the
front housing.
4. Remove O-ring seals (7) from the accessory drive.
126 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE