Disassembly and assembly

Illustration 224 g02951436
12. Install remaining bolts (5). Tighten the bolts in the
sequence that is shown in Illustration 224 to a
torque of 25 N·m (221 lb in).
13. Install the camshaft gear. Refer to Disassembly
and Assembly, “Camshaft Gear - Install” for the
correct procedure.
14. Install the fuel injection pump. Refer to
Disassembly and Assembly, “Fuel Injection Pump
- Install” for the correct procedure.
15. Install the engine oil pan . Refer to Disassembly
and Assembly, “Engine Oil Pan - Remove” for the
correct procedure.
16. If necessary, install the accessory drive. Refer to
Disassembly and Assembly, “Accessory Drive -
Remove and Install” for the correct procedure.
Illustration 225 g02951696
17. If necessary, follow Step 17.a through Step 17.c
in order to install engine oil filler (2).
a. Install new O-ring seal (4) (not shown) onto
engine oil filler (2).
b. Install engine oil filler (2) into front housing (1).
c. Install bolts (3) into engine oil filler (2). Tighten
the bolts to a torque of 25 N·m (221 lb in).
Illustration 226 g03025197
18. If necessary, install cover plate (8) to the front
housing. Follow Step 18.a through Step 18.c in
order to install the cover plate.
UENR0624-03 125
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE