Disassembly and assembly

Illustration 221 g02951196
Illustration 222 g02729111
Front housing sealant path.
Illustration 223 g02729108
4. Thoroughly clean the gasket surface of the front
housing (1) and the cylinder block.
5. If necessary, install dowels (6) (not shown) to the
cylinder block.
6. Install Tooling (B) into the cylinder block in
Positions (X).
7. Apply a 3mm bead of Tooling (A) to front housing
(1) as shown in Illustration 222 .
8. Install front housing (1) onto Tooling (B) and
dowels (6) (not shown).
9. Apply Tooling (C) onto the threads of bolts (5).
10. Install bolts (5) into front housing (1) in available
location finger tight.
11. Remove Tooling (B) from the cylinder block.
124 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE