Disassembly and assembly

7. If necessary, remove plug (7) in Position (Y) from
the front housing.
i05270839
Housing (Front) - Install
Installation Procedure
Table 43
Required Tools
Tool Part Number
Part Description Qty
A
-
Loctite 5970
Silicone Sealant
1
B
-
Guide Bolt
M8 x 1.25 by 35 mm
2
C
-
Loctite 506 1
D
-
Delphi Lockheed Com-
pound Rubber Grease
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shorten
component life.
1. Ensure that all components are clean and free
from wear and damage. If necessary, replace any
components that are worn or damaged.
Illustration 220 g03022878
2. If a new front housing is being installed, it will be
necessary to remove plug (7) in Position (Y) for
engines that are equipped with any accessory
drive in order to maintain the lubrication of the
accessory drive.
3. If the accessory drive was removed but will not be
installed, the oil gallery in Position (Y) must be
plugged. Follow Step 3.a through Step 3.c in order
to maintain engine oil circulation.
a. Apply Tooling (C) to plug (7).
b. Install plug (7) into front housing (1).
c. Tighten plug (7) to a torque of 15 N·m
(133 lb in).
UENR0624-03 123
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE