Disassembly and assembly

5. Remove bolt (12) from idler hub (10).
6. Remove the idler hub (10) and gear (9) from front
housing (13).
7. Remove idler hub (10) from gear (9).
8. If necessary, remove lubricating jet (11) from front
housing (13).
i05270835
Idler Gear - Install
Installation Procedure
Table 42
Required Tools
Tool Part Number
Part Description Qty
A
T400086
Timing Pin (Crankshaft)
1
B T400152
Timing Pin (Camshaft)
1
C
-
Loctite 506 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that all components are clean and free
from wear of damage. If necessary, replace any
components that are worn or damaged.
2. If Tooling (A) and Tooling (B) are not installed,
install Tooling (A) and install Tooling (B). Refer to
Disassembly and Assembly, “Idler Gear - Remove”
for the correct procedure.
Illustration 214 g02937163
Illustration 215 g02939977
3. If necessary, Apply Tooling (C) to lubricating jet
(11) and install the lubricating jet into front housing
(13). Tighten the lubricating jet to a torque of
18 N·m (159 lb in).
120 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE