Disassembly and assembly

d. Rotate the engine until Hole (X) in the camshaft
gear is aligned with Position (W) in the front
housing.
e. Install Tooling (B) through Position (W) and into
Hole (X) in the camshaft gear.
Illustration 211 g02934298
2. Follow Step 2.a through Step 2.c in order to install
the crankshaft positioning tool.
a. Remove plug (4) from Position (X) in the
cylinder block.
b. Remove O-ring seal (3) from plug (4).
c. Install Tooling (A) into the cylinder block in
Position (Z).
Note: Tooling (A) must be located in Hole (Y) in the
crankshaft.
Note: Ensure that Tooling (A) is located in the
correct drilling in the crankshaft as shown in
Illustration 211 .
Illustration 212 g02937163
Illustration 213 g02939977
3. Before removing the idler gear ensure that
alignment pin (6) on the fuel injection pump gear is
45 degrees from vertical and parallel to the center
of Torx head plug (5), refer to Illustration 212 .
4. Make temporary identification marks on idler hub
(10) for installation purposes.
UENR0624-03 119
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE