Disassembly and assembly

Procedure 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the crankshaft pulley adaptor and the
front cover are clean and free from oil and
damage.
Illustration 203 g02927218
Sectional view of the crankshaft front seal, the
crankshaft pulley adaptor, and the installation tool
2. Use Tooling (D) and follow Step 2.a through Step
2.f in order to install crankshaft front seal (1).
a. Position the adaptor of Tooling (D) onto the
crankshaft pulley adaptor and secure with bolts.
b. Position the new crankshaft front seal (1) over
the adaptor onto the front of the crankshaft.
c. Align the seal installer of Tooling (D) with the
crankshaft.
Note: Check that the installer of Tooling (D) is
parallel to the adaptor.
d. Install the nut and washer to the locator.
e. Tighten the nut until the installer bottoms out on
the adaptor in order to install crankshaft front
seal (1) into front cover (3) and onto crankshaft
pulley adaptor (2).
f. Remove Tooling (D).
End By:
a. Install the crankshaft pulley. Refer to
Disassembly and Assembly, “Crankshaft
Pulley - Remove and Install” for the correct
procedure.
Procedure 2
1. Ensure that the crankshaft pulley adaptor and the
front cover are clean and free from oil and
damage.
Illustration 204 g03805916
Sectional view of the crankshaft front seal, the
crankshaft pulley adaptor, and the installation tool
2. Use Tooling (D) and follow Step 2.a through Step
2.e in order to install crankshaft front seal (1).
a. Position the new crankshaft front seal (1) over
the nose of the crankshaft into the recess in the
front cover.
b. Position Tooling (D) onto the new crankshaft
front seal.
c. Align Tooling (D) with the crankshaft.
d. Use a suitable tool to drive (D) and the new
crankshaft front seal (1) into position.
e. Remove Tooling (D).
UENR0624-03 115
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE