Disassembly and assembly

End By:
a. Install the alternator belt. Refer to Disassembly
and Assembly, “Alternator Belt - Remove and
Install” for the correct procedure.
i06096313
Crankshaft Front Seal -
Remove and Install
Removal Procedure
Table 38
Required Tools
Tool Part Number
Part Description Qty
A
-
Drill Bit (3 mm)
1
B
27610311
Slide Hammer Puller 1
C
-
Telescopic Magnet
1
Start By:
a. Remove the crankshaft pulley. Refer to
Disassembly and Assembly, “Crankshaft
Pulley - Remove and Install” for the correct
procedure.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 202 g02927001
1. Apply clean grease to Tooling (A) in order to
prevent any swarf that is generated from entering
the engine. Use Tooling (A) to drill three evenly
spaced holes in crankshaft front seal (1).
2. Use Tooling (B) with care in order to remove
crankshaft front seal (1) from front cover (3) and
crankshaft pulley adaptor (2). Alternate the
position of Tooling (B) from one hole to another.
Alternating the position of Tooling (B) will allow the
crankshaft front seal to be easily removed from the
crankshaft.
3. Use Tooling (C) to collect any swarf that has
entered the engine.
Installation Procedure
Table 39
Required Tools
Tool Part Number
Part Description Qty
D
(1)
T400450
Crankshaft Front Seal
Installer
1
D
(2)
T400090
Crankshaft Front Seal
Installer
(1)
Used for Procedure 1
(2)
Used for Procedure 2
Note: The tool used is determined by which
crankshaft front seal is installed.
114 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE