Disassembly and assembly

NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Illustration 196 g02901518
Illustration 197 g02901685
1. If necessary, remove the Original Equipment
Manufacturer's (OEM) driven equipment from
power take-off drive (1). Refer to the OEM for the
correct procedure.
2. Remove bolts (2) from power take-off drive (1).
Note: Note the positions of the different length bolts.
3. Remove the power take-off drive (1) from the
cylinder block.
4. Remove O-ring seal (3) from power take-off drive
(1).
UENR0624-03 111
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE