Disassembly and assembly

Illustration 194 g02659276
2. Clean the rear face of the cylinder block. If
necessary, install dowels (5) to the cylinder block.
3. If necessary, install dowels (5) to the cylinder
block.
4. Apply a 3mm bead of Tooling (B) in Position (Y) to
the cylinder block as shown in Illustration 192 .
5. Install Tooling (A) into the cylinder block in
Positions (X).
6. Install a suitable lifting device onto the flywheel
housing. The weight of the flywheel housing is
approximately 40 kg (88 lb).
7. Use the suitable lifting device to align flywheel
housing (1) with Tooling (A). Install the flywheel
housing to the cylinder block.
8. Install bolts (4) and bolts (2) finger tight.
9. Remove Tooling (A). Install bolts (3) finger tight.
10. Tighten bolts (4) and bolts (2) to a torque of
110 N·m (81 lb ft).
11. Tighten bolts (3) to a torque of 35 N·m (26 lb ft).
12. Check the alignment of flywheel housing (1) with
the crankshaft. Refer to System Operation, Testing
and Adjusting, “Flywheel Housing - Inspect” for
more information.
Illustration 195 g02661536
13. If necessary, install inspection cover (6) and bolts
(7) to flywheel housing (1). Tighten the bolts to a
torque of 25 N·m (221 lb in).
14. Install the electric starting motor. Refer to
Disassembly and Assembly, “Electric Starting
Motor - Remove and Install” for the correct
procedure.
End By:
a. Install the engine oil pan. Refer to Disassembly
and Assembly, “Engine Oil Pan - Remove and
Install” for the correct procedure.
b. Install the crankshaft rear seal. Refer to
Disassembly and Assembly, “Crankshaft Rear
Seal - Remove and Install” for the correct
procedure.
i05270821
Power Take-Off Drive -
Remove and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
110 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE