Disassembly and assembly

Illustration 188 g02659276
Illustration 189 g02659298
1. Remove the electric starting motor. Refer to
Disassembly and Assembly, “Electric Starting
Motor - Remove and Install” for the correct
procedure.
2. If necessary install the diesel particulate filter
supporting bracket. Refer to Disassembly and
Assembly, “Support and Mounting (CEM) -
Remove and Install” for the correct procedure.
3. Remove bolts (3) from Position (X) from flywheel
housing (1).
4. Install Tooling (A) into Position (X) on flywheel
housing (1).
5. Install a suitable lifting device to the flywheel
housing in order to support the flywheel housing.
The weight of the flywheel housing is
approximately 40 kg (88 lb).
6. Remove bolts (2) from flywheel housing (1).
7. Remove bolts (4) from flywheel housing (1).
8. Use the suitable lifting device in order to remove
flywheel housing (1) from the cylinder block.
Illustration 190 g02882157
Illustration 191 g02661536
9. If necessary, remove dowels (5).
10. If necessary, remove bolts (7) and inspection
cover (6) from flywheel housing (1).
108 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE