Disassembly and assembly

4. Install a suitable lifting device to the flywheel
housing in order to support the flywheel housing.
The weight of the flywheel housing is
approximately 40 kg (88 lb).
5. Remove bolts (2) from flywheel housing (1).
6. Remove bolts (4) from flywheel housing (1).
7. Use the suitable lifting device in order to remove
flywheel housing (1) from the cylinder block.
Illustration 184 g02879456
8. If necessary, remove dowels (5).
Installation Procedure
Table 34
Required Tools
Tool Part Number
Part Description Qty
A
-
Guide Stud
M8 by 100 mm
2
B
-
Loctite 5970 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the flywheel housing is clean and free
from damage. If necessary, replace the flywheel
housing.
Illustration 185 g02881996
Illustration 186 g02879298
106 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE