Disassembly and assembly

End By:
a. Install the flywheel. Refer to Disassembly and
Assembly, “Flywheel - Install”.
i05270813
Flywheel Housing - Remove
and Install
(Stressed Cylinder Block)
Removal Procedure
Table 33
Required Tools
Tool Part Number
Part Description Qty
A
-
Guide Stud
M8 by 100 mm
2
Start By:
a. Remove the crankshaft rear seal. Refer to
Disassembly and Assembly, “Crankshaft Rear
Seal - Remove and Install” for the correct
procedure.
b. Remove the engine oil pan. Refer to
Disassembly and Assembly, “Engine Oil Pan -
Remove and Install” for the correct procedure.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 182 g02879298
Illustration 183 g02879337
1. Remove the electric starting motor. Refer to
Disassembly and Assembly, “Electric Starting
Motor - Remove and Install” for the correct
procedure.
2. Remove bolts (3) from Position (X) from flywheel
housing (1).
3. Install Tooling (A) into Position (X) on flywheel
housing (1).
UENR0624-03 105
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE