Disassembly and assembly

Installation Procedure
Table 32
Required Tools
Tool Part Number
Part Description Qty
D
T400089
Crankshaft Rear Seal
Installer
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the flange of the crankshaft and the
inside of the flywheel housing are clean and free
from oil and damage.
Illustration 180 g02876556
Typical example
Illustration 181 g02876596
Sectional view of the crankshaft rear seal, the
crankshaft, and the installation tool
2. Crankshaft rear seal (4) and crankshaft wear
sleeve (3) are supplied as a crankshaft rear seal
assembly (5) and should not be separated for
installation.
Note: Do not remove the crankshaft rear seal from
the crankshaft wear sleeve.
3. Use Tooling (D) and follow Step 3.a through Step
3.f in order to install crankshaft rear seal assembly
(5).
a. Position the adaptor of Tooling (D) onto the
palm of the crankshaft and secure with bolts.
b. Position the new crankshaft rear seal assembly
(5) over the adaptor onto the rear of the
crankshaft.
c. Align the seal installer of Tooling (D) with the
crankshaft.
Note: Check that the installer of Tooling (D) is
parallel to the adaptor.
d. Install the nut and washer to the locator.
e. Tighten the nut until the installer bottoms out on
the adaptor in order to install crankshaft rear
seal assembly (5) into flywheel housing (1) and
onto crankshaft (2).
f. Remove Tooling (D).
104 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE