Disassembly and assembly

4. Install bolt (13) finger tight to lifting bracket (11).
Tighten the bolt to a torque of 110 N·m (81 lb ft).
5. Position lifting bracket (12) onto the flywheel
housing. Refer to Illustration 174 .
6. Install bolt (14) finger tight to lifting bracket (12).
Tighten the bolts to a torque of 110 N·m (81 lb ft).
i05270805
Flywheel - Remove
Removal Procedure
Table 29
Required Tools
Tool Part Number
Part Description Qty
A
-
Guide Stud
M12 x 1.25mm by 100mm
2
Start By:
a. Remove the electric starting motor. Refer to
Disassembly and Assembly, “Electric Starting
Motor - Remove and Install” for the correct
procedure.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 175 g02657336
1. Remove bolts from Position (X) from flywheel (1).
Discard the bolts.
2. Install Tooling (A) in Position (X) to flywheel (1).
3. Install a suitable lifting device onto flywheel (1).
Support the weight of the flywheel. The flywheel
can weigh 75 kg (165 lb).
4. Remove remaining bolts (2). Discard the bolts.
5. Use the suitable lifting device to remove the
flywheel from the engine.
Illustration 176 g02657439
6. Inspect flywheel (1) and ring gear (3) for wear and
damage. Replace any worn or damaged
components.
7. To remove flywheel ring gear (3), follow Step 7.a
through Step 7.b.
UENR0624-03 101
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE