Disassembly and assembly

Illustration 14 g01016669
Typical example
Example of damage to the convolutions
Inspect the bellows for damage. The part should be
discarded if damage to the convolutions is present.
Illustration 14 shows that damage to the
convolutions.
Illustration 15 g02240434
Typical example
Example of a bad edge
If damage has occurred to the edges of the bellow,
the bellows must be replaced.
i05268254
Fuel Priming Pump - Remove
and Install
Removal Procedure
Table 1
Required Tools
Tool Part Number
Part Description Qty
A
T412504
Capping Kit
1
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorized personnel that have the correct
training.
Before beginning ANY work on the fuel system,
refer to Operation and Maintenance Manual,
“General Hazard Information and High Pressure
Fuel Lines” for safety information.
Refer to System Operation, Testing and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
1. Turn the fuel supply to the OFF position.
10 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE