User Manual

5. Move the dial indicator so that the dial indicator will
measure the circumference of the crankshaft
pulley. Set the dial indicator to read 0.00 mm
(0.00 inch).
6. Slowly rotate the crankshaft in order to measure
the runout of the circumference of the crankshaft
pulley. Use the highest reading and the lowest
reading on the dial indicator. The maximum and
the minimum readings on the dial indicator should
not vary more than 0.12 mm (0.005 inch).
If the reading on the dial indicator is more than
0.12 mm (0.005 inch), inspect the pulley for
damage. If the pulley is damaged, use new parts
for replacement.
86 UENR0623-02
Basic Engine
This document has been printed from SPI2. NOT FOR RESALE