Disassembly and assembly

KENR6226-01 99
Disassembly and Assembly Section
i02645652
Altern ato r - Remove and Insta ll
(55 Amp Alternator)
Removal Procedure
Start By:
a. Remove the V-Belt. Refer to Disassembly and
Assembly, “V-
Belts - Remove and Install”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Turn the battery disconnect switch to the OFF
position.
2. Make temporary identification marks on the
connections of the harness assembly.
g01308282
Illustration 186
Typical example
3. Disconnect the harness assembly (not shown)
from alternator (5).
4. Remove bolt (2) and washer (3) from alternator
(5).
5. Remove fasteners (6) and (7) and remove
alternator (5) from the mounting bracket.
6. If necessary, remove bolt (2) and remove adjusting
link (4).
Installation P
rocedure
g01308282
Illustration 187
Typical example
1. If necessary, install adjusting link (4) and install
bolt (1) finger tight.
2. Position alternator (5) on the mounting bracket.
3. Install fasteners (6) and (7) finger tight.
4. Install bolt (2) and washer (3) finger tight.
5. Install the V-Belt. Refer to Disassembly and
Assembly, “V-Belts - Remove and Install”.
Note: Ensure that the alternator pulley is in alignment
with the crankshaft pulley. Ensure that all fasteners
are tightened.
6. Connect the harness assembly (not shown) to the
alternator.
7. Turn the battery disconnect switch to the ON
position.
i02645651
Alternator - Remove and Install
(40 Amp Alternator)
Removal Procedure
Start By:
a. Remove the V-Belt. Refer to Disassembly and
Assembly, “V-Belts - Remove and Install”.
This document has been printed from SPI². Not for Resale