Disassembly and assembly

96 KENR6226-01
Disassembly and Assembly Section
i02645773
V-Belts - Remove and Install
Removal Proced
ure
NOTICE
Keep all parts c
lean from contaminants.
Contaminants may cause rapid wear and shortened
component life
.
1. Iftheengineisequippedwithfanguards,remove
the fan guards.
g01325726
Illustration 180
Typical example
2. Loosen bolts (1), (2) and (4).
3. Push alternator (3) toward the engine and remove
V-belt (5).
Note: Mark the direction of rotation if the V-belt will
be reused.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01325726
Illustration 181
Typical example
1. Check the condition of the V-belt . If the V-belt
is worn or damaged, use a new V-belt for
replacement.
2. Install V-belt (5) in position on the engine.
Note: A used V-belt should be installed in the original
direction of rotation.
3. Slide alternator (3) away from the engine. Refer to
Systems Operation, Testing and Adjusting, “Belt
Tension Chart” for information on the correct belt
tension. T ighten bolts (1), (2) and (4) to a torque
of 25 N·m (18 lb ft).
4. If the engine is equipped with fan guards, install
the fan guards.
i02645681
Fan - Remove an d Install
Removal Procedure
Start By:
a. Remove the V-Belt. Refer to Disassembly and
Assembly, “V-Belts - Remove and Install”.
This document has been printed from SPI². Not for Resale