Disassembly and assembly

KENR6226-01 93
Disassembly and Assembly Section
Installation P
rocedure
Table 32
Required Tools
Tool Part Number Part Descripti
on
Qty
A
21820122
POWERPART
Pipe Sealant
1
NOTICE
Keep all parts clean from contaminants.
Contaminants m
ay cause rapid wear and shortened
component life.
1. Inspect the coolant temperature switch for
damage and correct operation. Refer to Systems
Operation, Testing and Adjusting, “Coolant
Temperature Switch - Test” for more information.
If necessary, replace the coolant temperature
switch.
g01325724
Illustration 173
Typical example
2. Install coo
lant temperature switch (1) to water
pump (2). Use a deep socket to tighten the coolant
temperature switch to a torque of 27 N·m (20 lb ft).
Note: Ifausedcoolanttemperatureswitchis
installed, apply a thin layer of Tooling (A) to the
threads of
the coolant temperature switch.
3. Connect the harness assembly (not shown) to
coolant te
mperature switch (1).
4. Fill the cooling system with coolant to the correct
level. Ref
er to Operation and Maintenance
Manual, “Cooling System Coolant - Fill” for more
information.
i02645676
Engine O il Pressure Switch -
Remove and Ins tall
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants m
ay cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting
and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent contain
ing fluids.
Dispose of all fluids according to local regulations and
mandates.
Note: The engine oil pressure switch may be located
in the valve mechanism cover or in the cylinder block.
Refer to Spec
ifications, “Engine Oil Pressure Switch”
for the correct location.
g01307413
Illustr
ation 174
Typical example
This document has been printed from SPI². Not for Resale