Disassembly and assembly

KENR6226-01 9
Disassembly and Assembly Section
4. Loosen hose clamps (4) and (5). Disconnect
hoses (6) and (7
).
5. Remove bolts (2) and remove electric transfer
pump (3).
Installation
Procedure
1. Ensure that the electric transfer pump is clean
and free from d
amage. If necessary, replace the
electric transfer pump.
g01304057
Illustration 8
Typical example
2. Position el
ectric transfer pump (3) on the mounting
and install bolts (2).
3. Tighten bol
ts (2) to a torque of 9 N·m (79 lb in).
4. Connect hoses (6) and (7). Tighten hose clamps
(4) and (5)
.
5. Connect harness assembly (1).
6. Turn the fuel supply to the ON position.
7. Turn the ba
ttery disconnect switch to the ON
position.
8. Remove the
air from the fuel system. Refer to
Operation and Maintenance Manual, “Fuel System
- Prime”.
i02959953
Fuel Injection Lines - Remov e
and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants m
ay cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting
and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent contain
ing fluids.
Dispose of all fluids according to local regulations and
mandates.
NOTICE
Do not let the tops of fuel injectors turn when the fuel
line nuts are loosened or tightened.
The fuel injectors will be damaged if the top of the
injector turns in the body.
The engine will be damaged if a defective fuel injector
is used because the shape of fuel (spray pattern) that
comes out of the nozzle will not be correct.
Note: Place identification marks on all tube
assemblies for installation. Plug all lines and tube
assemblies in order to prevent contamination.
1. Turn the fuel supply to the OFF position.
This document has been printed from SPI². Not for Resale