Disassembly and assembly

88 KENR6226-01
Disassembly and Assembly Section
g01485933
Illustration 164
1. Use Tooling (A) to install crankshaft bearing (9) to
the cylinder block. Follow Steps 1.a through 1.c in
order to install the crankshaft bearing.
a. Ensure that oil supply hole (12) is aligned with
the oil gallery in the cylinder block.
b. Ensure that joint (10) is upward.
c. Ensure that chamfer (11) faces toward the
cylinder block.
End By:
a. Install the crankshaft assembly. Refer to
Disassembly and Assembly, “Crankshaft - Install”.
i02645665
Cranksh aft - Remo ve
Removal Procedure
Start By:
a. Remove the engine oil relief valve. Refer to
Disassembly and Assembly, “Engine Oil Relief
Valve - Remove and Install”.
b. Remove the crankshaft rear seal. Refer to
Disassembly and Assembly, “Crankshaft Rear
Seal - Remove and Install”.
c. Remove the engine oil pump and the suction pipe.
Refer to Disass
embly and Assembly, “Engine Oil
Pump - Remove”.
d. Remove the pis
tons and the connecting rods.
Refer to Disassembly and Assembly, “Pistons and
Connecting Rods - Remove”.
NOTICE
Keep all parts clean from contaminants.
Contaminants
may cause rapid wear and shortened
component life.
1. The engine should be mounted in a suitable stand
with the rear end upward.
g01311526
Illustration 165
Typical example
2. Remove bolts (2) from the cylinder block.
3. Remove allen head screws (1) from the cylinder
block.
This document has been printed from SPI². Not for Resale