Disassembly and assembly

KENR6226-01 81
Disassembly and Assembly Section
g01311807
Illustrat
ion 152
Typical example
3. Lubricate the bush in connecting rod (1) and
lubricate the bore for the piston pin in piston (2)
with clea
nengineoil.
4. Place the piston on a suitable surface with the
crown dow
nward. Install connecting rod (1) and
piston pin (3) to piston (2). The name Shibaura
inside the piston must align with the stamped
number o
n the connecting rod. Ensure the correct
orientation of the connecting rod in the piston.
Note: If
the piston pin cannot be installed by hand,
heat the piston to a temperature of 45 ± 5 °C
(113 ± 9 °F). Do not use a torch to heat the piston.
5. Use Tooling (A) in order to install retaining rings
(4) to the piston pin bore in piston (2).
Note: Ensure that the retaining rings are seated in
the grooves in the piston.
g01311837
Illustrat
ion 153
Typical example
6. Install the upper half of connecting rod bearing
(8) to connecting rod (1).
7. Install the lower half of connecting rod bearing (9)
to connecting rod cap (10).
End By:
a. Install t
he pistons and the connecting rods.
Refer to Disassembly and Assembly, “Piston and
Connecting Rods - Install”.
i02961862
Pistons and Connecting Rods
-Install
Installation Procedure
Table 26
Required Tools
Tool Part
Number
Part Description
Qty
A
21825491
Piston Ring Compressor 1
This document has been printed from SPI². Not for Resale