Disassembly and assembly

8 KENR6226-01
Disassembly and Assembly Section
g01326306
Illustration 6
Typical example
1. Clean the mating surfaces of the cylinder block
and flange (5) on the fuel transfer pump.
Note: Ensure that the camshaft lobe for the fuel
transfer pump is at minimum lift before the fuel
transfer pump is installed. The fuel transfer pump
canbeorientedintwopositions.Ensurethatthefuel
transfer pump is oriented in the correct position.
2. Install a new O-ring seal (3) to fuel transfer pump
(1).
3. Lubricate the operating plunger of fuel transfer
pump (1) with clean engine oil.
4. Position fuel transfer pump (1) on the cylinder
block. Ensure that the operating plunger is
positioned correctly on the camshaft lobe. Install
bolts (4). Tighten the bolts to a torque of 6 N·m
(53lbin).
5. Connect the hoses (not shown) to fuel transfer
pump (1). Tighten the hose clamps.
Note: The inlet for the fuel transfer pump can be
rotated 360 degrees by loosening bolt (2). The
fuel inlet is adjustable in 15 degree increments. If
adjustment is made to the position of the fuel inlet,
tighten bolt (2) to a torque of 2.5 N·m (22 lb in).
6. Turn the fuel supply to the ON position.
7. Prime the fuel system. Refer to Systems
Operation, Testing and Adjusting, “Fuel System -
Prime” for additional information.
i02645719
Fuel Transfer Pump - Re mo ve
and Install
(Electrical Fu
el Transfer Pump)
Removal Procedure
NOTICE
Care must be taken to ensure that fluids are contained
during perform
ance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compar
tment or disassembling any compo-
nent containing fluids.
Dispose of all
fluids according to local regulations and
mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: Put identification marks on all hoses, on all
hose assembl
ies, on wires and on all tube assemblies
for installation purposes. Plug all hose assemblies
and tube assemblies. This helps to prevent fluid loss
and this help
s to keep contaminants from entering
the system.
1. Turn the fue
l supply to the OFF position.
2. Turn the battery disconnect switch to the OFF
position.
g01304057
Illustration 7
Typical ex
ample
3. Disconnect harness assembly (1).
This document has been printed from SPI². Not for Resale