Disassembly and assembly

72 KENR6226-01
Disassembly and Assembly Section
2. Repeat Step 1 for the remaining lifters.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
It is strongly recommended that all lifters should be
replaced when a
new camshaft is installed.
g00692979
Illustration 133
1. Clean lifters (1). Follow Steps 1.a through 1.c in
order to inspect the lifters. Replace lifters that are
worn or damaged.
a. Inspect the seat of the pushrod in the lifter for
visual wear or damage. Ensure that oil holes in
the lifter are not restricted.
b. Inspect the shank of the lifter for wear or
damage. Refer to Specifications, “Lifter Group”
for more information.
c. Inspect the face of the lifter that runs on the
camshaft for visual wear or damage.
2. Lubricate lifters (1) with clean engine oil.
3. Install lifters (1) into the cylinder block.
Note: Theliftersshouldbefreetorotate.Ifthelifters
have been used, ensure that the lifters are installed
in the original positions.
End By:
a. Install the cylinder head. Refer to Disassembly
and Assembly, “Cylinder Head - Install”.
i02963920
Camshaft - R em ove
Removal Proced
ure
Start By:
a. Remove the lifters. Refer to Disassembly and
Assembly, “Lifter Group - Remove and Install”.
b. Remove the front housing. Refer to Disassembly
and Assembly, “Housing (Front) - Remove”.
NOTICE
Keep all parts clean from contaminants.
Contaminants
may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjustin
g and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent contain
ing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. If the engine is equipped with a mechanical fuel
transfer pump, remove the fuel transfer pump.
Refer to Dis
assembly and Assembly, “Fuel
Transfer Pump - Remove and Install”.
This document has been printed from SPI². Not for Resale