Disassembly and assembly

KENR6226-01 7
Disassembly and Assembly Section
i02645722
Fuel Transfer Pump - Remove
and Install
(Mechanical Fu
el Transfer
Pump)
Removal Proce
dure
NOTICE
Do not allow di
rt to enter the fuel system. Thoroughly
clean the area around a fuel system component that
will be disconnected. Fit a suitable cover over discon-
nected fuel sy
stem component.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: Place identification marks on all hoses for
installation purposes. Plug all hoses and all the
ports in the fuel transfer pump. This helps prevent
fluid loss, and this helps to keep contaminants from
entering the system.
1. Turn the fuel supply to the OFF position.
g01326306
Illustration 5
Typical example
Note: The fuel transfer pump can be oriented in two
positions. Before removing the fuel transfer pump
from the cylinder block, note the orientation of flange
(5) on fuel transfer pump (1) for assembly.
2. Loosen the hose clamps and disconnect the
hoses (not shown) from fuel transfer pump (1).
3. Evenly loosen bolts (4) and remove fuel transfer
pump (1) from the cylinder block.
Note: In order to remove the fuel transfer pump, it
may be necessary to rotate the crankshaft until the
operating plunger of the fuel transfer pump is not
under pressure.
4. Remove O-ring seal (3) from fuel transfer pump
(1).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
This document has been printed from SPI². Not for Resale