Disassembly and assembly

60 KENR6226-01
Disassembly and Assembly Section
2. If necessary, follow Steps 2.a through 2.d in order
to install the g
auze for the breather.
a. Install gauze (6) to valve mechanism cover (7).
b. Position plate (9) on valve mechanism cover
(7) and install screws (8).
c. Tighten screws (8) to a torque of 1.5 N·m
(13lbin).
d. Install valve mechanism cover (7). Refer to
Disassembly and Assembly, “Valve Mechanism
Cover - Remov
e and Install” for the correct
procedure.
Personal injury can result from being struck by
parts propelled by a released spring force.
Make sure to wear all necessary protective equip-
ment.
Follow the recommended procedure and use all
recommended tooling to release the spring force.
3. Install diaphragm (4) and spring (3) to cover (2).
4. Position the assembly of cover (2), spring (3) and
diaphragm (4) onto valve mechanism cover (7).
Note: Ensure the correct orientation of the cover.
5. Install bolts (1). Use Tooling (A) in order to tighten
boltstoatorqueof3N·m(27lbin).
i02961022
Valve M ech
anism Cover -
Remove and Install
Removal Pr
ocedure
NOTICE
Keep all pa
rts clean from contaminants.
Contaminants may cause rapid wear and shortened
component
life.
NOTICE
Care must be taken to ensure that fluids are contained
during perform
ance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compar
tment or disassembling any compo-
nent containing fluids.
Dispose of all
fluids according to local regulations and
mandates.
Note: The removal procedure is similar for the two
cylinder, the
three cylinder and the four cylinder
engines. The illustrations show the four cylinder
engine.
g01316539
Illustration 109
Typical example
1. Loosen the hose clamps and disconnect the hose
(not shown) from connection (2).
g01316551
Illustration 110
Typical example
This document has been printed from SPI². Not for Resale