Disassembly and assembly

6 KENR6226-01
Disassembly and Assembly Section
g01303701
Illustration 3
Typical example
2. Loosen hose clamps (3) and disconnect hoses (4).
3. If necessary, remove fuel filter element (5). Refer
to Operations and Maintenance Manual, “Fuel
System Filter - Replace”.
4. Remove bolt (1) and remove fuel filter base (2)
from the mounting bracket.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the fuel filter base is clean and free
from damage. If necessary, replace the fuel filter
base.
g01303701
Illustration 4
Typical example
2. Align fuel filter base (2) with the mounting bracket.
Install bolt (1). Tighten the bolt to a torque of
25 N·m (18 lb ft).
3. If necessary, install a new fuel filter element
(6) to fuel filter base (2). Refer to Operation
and Maintenance Manual, “Fuel System Filter -
Replace”.
4. Connect hoses (4) and tighten hose clamps (3).
Note: Ensure that the hoses do not contact any other
engine components.
5. Turn the fuel supply to the ON position.
6. Remove the air from the fuel system. Refer to
Operation and Maintenance Manual, “Fuel System
- Prime”.
This document has been printed from SPI². Not for Resale