Disassembly and assembly

KENR6226-01 59
Disassembly and Assembly Section
g01307795
Illustrat
ion 107
Typical example
Personal injury can result from parts and/or cov-
ers under spring pressure.
Spring force will be released when covers are re-
moved.
Be prepared to hold spring loaded covers a s the
bolts are loosened.
1. Remove bolts (1) and remove the assembly of
cover (2), spring (3) and diaphragm (4). Note the
orientation of cover (2).
2. Remove spring (3) and diaphragm (4) from cover
(2).
3. If necessary, follow Steps 3.a through 3.c in order
to remove the gauze for the breather.
a. Remove valve mechanism cover (7). Refer to
Disassembly and Assembly, “Valve Mechanism
Cover - Remove and Install” for the correct
procedure.
b. Remove screws (8) and carefully remove plate
(9).
c. Remove gauze (6) from valve mechanism
cover (7).
Installation P
rocedure
Table 18
Required Tools
Tool
Part
Number
Part Description
Qty
A
27610296
Torque Wrench 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Make sure that the components of the breather as-
sembly are installed correctly. Engine damage may
occur if the breather assembly is not working properly.
The two cylinder, the three cylinder and the four
cylinder engines have different crankcase breathers.
The installation procedure is similar for all models.
g0130779
5
Illustration 108
Typical example
1. Clean all p
arts and inspect all parts. Replace any
parts that are worn or damaged. Ensure that the
cavity for the breather in the valve mechanism
cover is c
lean. Ensure that vent hole (5) and the
vent hole in cover (2) are free from restriction.
This document has been printed from SPI². Not for Resale