Disassembly and assembly

KENR6226-01 57
Disassembly and Assembly Section
g01310618
Illustrat
ion 105
Typical example
Personal injury can result from parts and/or cov-
ers under spring pressure.
Spring force will be released when covers are re-
moved.
Be prepared to hold spring loaded covers a s the
bolts are loosened.
1. Remove bolts (1) and remove the assembly of
cover (2), spring (3) and diaphragm (4). Note the
orientation of cover (2).
2. Remove spring (3) and diaphragm (4) from cover
(2).
3. Remove adapter (5) and joint (6) from valve
mechanism cover (7).
Note: Make a temporary mark in order to show the
orientation of the adapter for installation.
4. If necessary, follow Steps 4.a through 4.c in order
to remove the gauze for the breather.
a. Remove valve mechanism cover (7). Refer to
Disassembly and Assembly, “Valve Mechanism
Cover - Remove and Install” for the correct
procedure.
b. Remove screws (9) and carefully remove plate
(10).
c. Remove gauze (8) from valve mechanism
cover (7).
Installation
Procedure
Table 17
Required Tools
Tool Part Number Part Description Qty
A
27610296
Torque Wrench 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Make sure that the components of the breather as-
sembly are installed correctly. Engine damage may
occur if the breather assembly is not working properly.
g01310618
Illustration 106
Typical example
This document has been printed from SPI². Not for Resale