Disassembly and assembly

KENR6226-01 55
Disassembly and Assembly Section
12. If the position of stop (16) has been altered, the
stop must be res
et. Refer to Systems Operation,
Testing and Adjusting, “Governor” for the correct
procedure.
13. Install the front housing. Refer to Disassembly
and Assembly, “Housing (Front) Install” for more
information
.
14. Set the position of the spring assembly (17).
Refer to Illu
stration 95. The procedure that is
used to set the position of the spring assembly
is described in Systems Operation, Testing and
Adjusting, “
Govenor”. Tighten the spring assembly
to a torque of 34 N·m (25 lb ft).
15. Install a new
new cap (21) to nut (20). Refer to
Illustration 95.
i02965670
Housing (Front) - Install
Installati
on Procedure
Table 16
Required Tools
Tool
Part
Number
Part Description
Qty
A
(1)
21825620
Seal Protector 1
A
(2)
21825621
Seal Protector 1
(1)
402D-05, 403D-07, 40 3D-11 a nd 404D-16 engines
(2)
403D-15, 403D-15T, 403D-17, 404D-22, 404D-22T and
404D-22TA engines
NOTICE
Keep all parts clean from contaminants.
Contaminan
ts may cause rapid wear and shortened
component life.
g01494813
Illustrat
ion 102
Typical example
g014955
33
Illustration 103
Typical example
This document has been printed from SPI². Not for Resale