Disassembly and assembly

52 KENR6226-01
Disassembly and Assembly Section
g01357727
Illustration 92
Typical example
8. Disconnect spring (12) from front housing (3).
9. Remove nut (14) and remove sealing washer (13)
from front housing (3).
10. Remove shaft (15) and remove lever assembly
(11) from front housing (3).
g01358077
Illustration 93
Typical example
11. Remove spring assembly (17) and remove
sealing washer (18) from front housing (3).
Note: The position of fuel screw (16) controls
the emissions o
f the engine. Do not remove the
fuel screw unless a d ifferent front housing will
be installed. Do not adjust the fuel screw. Refer
to Systems Ope
ration, Te sting and Adjusting,
“Governor” for further information.
12. If necessary
, remove cap (21), locknut (20)
and sealing washer (19) from front housing (3).
Remove fuel screw (16).
i02706594
Housing (Fron t) - Assem ble
Assembly Procedure
Table 15
Required Tools
Tool
Part
Number
Part Description Qty
A
21820117
POWERPART
Thread Lock
1
Improper assembly of parts that are spring loaded
can cause bodily injury.
To prevent possible injury, follow the established
assembly procedure and wear protective equip-
ment.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
This document has been printed from SPI². Not for Resale