Disassembly and assembly

50 KENR6226-01
Disassembly and Assembly Section
g01357158
Illustrat
ion 86
Typical example
1. If the engine is equipped with a turbocharger,
disconnect the hose from connection (1).
2. Remove nuts (4) and bolts (9).
3. Remove co
ver (8) and O-ring seal (7).
4. Remove fasteners (3). Identify the position of the
differen
t fasteners for installation.
5. Carefully remove front housing (6) from plate (5).
Ensure th
at pin (2) remains in the front housing.
Note: The front housing is aligned to the plate and
to the cyl
inder block with dowels.
6. Remove the joint (not shown).
i02902054
Housing (Front) - Disassemble
Disassembly Pr
ocedure
Start By:
a. Record the governor settings. Refer to Systems
Operation, Testing and Adjusting, “Govener -
Adjust”
b. Remove the engine front housing. Refer to
Disassembly a
nd Assembly, “Housing (Front) -
Remove”.
Personal injury can result from being struck by
parts propelled by a released spring force.
Make sure to wear all necessary protective equip-
ment.
Follow the recommended procedure and use a ll
recommended tooling to release the spring force.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01357675
Illustration 87
Typical example
1. Remove spr
ing (4) from arm (2) on the assembly
of throttle control (1).
This document has been printed from SPI². Not for Resale