Disassembly and assembly

48 KENR6226-01
Disassembly and Assembly Section
For 403D-11 and 404D-15 engines, tighten nut (5)
to a torque of 12
3 N·m (91 lb ft).
For 403D-15, 403D-15T, 403D-17, 404D-22,
404D-22T and 4
04D-22TA engines, tighten nut (5)
toatorqueof304N·m(224lbft).
End By:
a. Install the V-belt to the engine. Refer to
Disassembly a
nd Assembly, “V Belts Remove and
Install”.
i02645666
Crankshaft Front Seal -
Remove and Install
Removal Procedure
Table 14
Required Tools
Tool
Part
Number Part D escrip
tion
Qty
A
27610311
Slide Hammer Puller
1
Start By:
a. Remove the crankshaft pulley. Refer to
Disassembly and Assembly, “Crankshaft Pulley
- Remove and Install”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01310976
Illustration 84
Typical example
1. Use a 4 mm (0.158 inch) drill in order to make
three holes in crankshaft front seal (2).
NOTICE
Ensure that the main lip is used in order to remove the
crankshaft front seal. Do not damage the edge of the
housing for the crankshaft front seal.
Note: Do not damage the crankshaft during the
removal process of the crankshaft front seal.
2. Use Tooling (A) to carefully remove crankshaft
front seal (2). Alternate the position of Tooling (A)
from one hole to another hole. This will allow you
to evenly remove the crankshaft front seal from
front housing (1).
Alternative Removal Procedure
Start By:
a. Remove the crankshaft pulley. Refer to
Disassembly and Assembly, “Crankshaft Pulley
- Remove and Install”.
b. Remove the front housing. Refer to Disassembly
and Assembly, “Housing (Front) - Remove”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
This document has been printed from SPI². Not for Resale