Disassembly and assembly

KENR6226-01 47
Disassembly and Assembly Section
6. Remove the lifting device from the flywheel
housing.
7. Install bolts (3) and (4) that fasten flywheel
housing (8) to
the cylinder block.
8. Tighten the fasteners to a torque of 25 N·m
(19 lb ft).
End By:
a. Install the flywheel. Refer to Disassembly and
Assembly, “Flywheel - Install”.
i02961010
Cranksh aft Pulley - Remov e
and Install
Removal Procedure
Start By:
a. Remove the V-belt. Refer to Disassembly and
Assembly, “V Belts Remove and Install” for more
information.
Table 13
Required Tools
Tool
Part
Number
Description Qty
21825619
Puller 1
A
-
Bolt 3
g01326646
Illustration 81
Typical example
1. Loosen nut (3).
Note: Do not remove the nut at this time.
g01305772
Illustration 82
2. Install Tooling (A) to crankshaft pulley (2). Use
Tooling (A) in order to remove crankshaft pulley
(2) from crankshaft (4). Remove Tooling (A).
3. Remove nut (3).
4. Remove pulley (2) from crankshaft (4).
5. Remove woodruff key (1) from crankshaft (4).
Installation Procedure
1. Ensure that the following components are
clean and free from damage: the taper of the
crankshaft, the woodruff key, and the bore of
the crankshaft pulley. Replace any components
that are damaged. Ensure that the taper of the
crankshaft and the bore of the crankshaft pulley
are clean and dry before assembly.
g01326646
Illustr
ation 83
Typical example
2. Install woodruff key (1) to crankshaft (4).
3. Install c
rankshaft pulley (2) to crankshaft (4).
4. Lubricate nut (3) with clean engine oil and install
the nut.
For 402D-05 and 403D-07 engines, tighten nut (5)
to a torq
ue of 93 N·m (69 lb ft).
This document has been printed from SPI². Not for Resale