Disassembly and assembly

46 KENR6226-01
Disassembly and Assembly Section
g01305649
Illustration 78
Typical example
3. Remove bolts (3) and (4) that fasten flywheel
housing (8) to the cylinder block.
4. Remove bolts (6) on each side of the cylinder
block. These bolts fasten flywheel housing (8) to
the cylinder block.
5. Remove bolts (1) that fasten back plate (2) to
flywheel housing (8).
6. Remove nuts (5) and the bolts (not shown) that
fasten back plate (2) to flywheel housing (8).
7. Carefully remove flywheel housing (8) from back
plate (2) and dowels (7). Use a suitable lifting
device to remove the flywheel housing.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the mating surfaces of back plate
(2) and flywheel housing (8) are clean and free
from damage. Inspect the crankshaft rear seal
(not shown) for leaks. If necessary, replace the
crankshaft rear seal. Refer to Disassembly and
Assembly, “Crankshaft Rear Seal - Remove and
Install” for the correct procedure. Inspect dowels
(7) for damage. If the dowels are damaged, use
new parts for replacement.
g01305649
Illustration 79
g01326591
Illustration 80
Typical
example
2. Use a suitable lifting device to align flywheel
housing
(8) to dowels (7). The weight of the
flywheel housing is approximately 30 kg (66 lb).
Install the flywheel housing to the back plate.
3. Install nuts (5) and the bolts (not shown) that
fasten back plate (2) to flywheel housing (8).
4. Install bolts (1) that fasten back plate (2) to
flywheel housing (8).
5. Install bolts (6) on each side of the cylinder block.
These bolts fasten flywheel housing (8) to the
cylind
er block.
This document has been printed from SPI². Not for Resale