Disassembly and assembly

42 KENR6226-01
Disassembly and Assembly Section
g01305376
Illustration 70
Typical example
1. Remove bolts (3) and remove the flywheel housing
or back plate (2) from the cylinder block. Refer to
Disassembly and Assembly, “Flywheel Housing -
Remove and Install” for more information.
2. Remove crankshaft rear seal (1) from the cylinder
block. Discard the crankshaft oil seal.
Installation Procedure
Table 11
Required Tools
Tool Part Number Part Description
Qty
A
21826038
POWERPART
Silicone Adhesive
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01305365
Illustration 71
Typical example
1. Ensure that the mating surface of cylinder block
(5) and the fl ywheel housing or back plate (2) are
clean and free from damage. Inspect dowels (4).
If the dowels are damaged, use new parts for
replacement.
2. Ensure that crankshaft flange (6) is clean and free
from damage. It is possible to reclaim a crankshaft
flange that has a worn seal surface, or a damaged
seal surface by installing a wear sleeve. Refer to
Disassembly and Assembly, “Crankshaft Wear
Sleeve (Rear) - Remove and Install” for more
information.
3. Apply clean engine lubricating oil to the flange
of crankshaft (6) around the running surface of
crankshaft rear seal.
4. Align a new crankshaft rear seal (1) with the flange
of crankshaft (6). Carefully install crankshaft rear
seal (1) onto the crankshaft flange.
5. Apply a continuous bead of Tooling (A) to the
rear face of the cylinder block around the edge of
crankshaft rear seal (1). Apply a continuous bead
of Tooling (A) around plug (X).
6. Align the flywheel housing or back plate (2)
to dowels (4). Install the flywheel housing or
back plate (2) and install bolts (3) to cylinder
block (5). Refer to Disassembly and Assembly,
“Flywheel Housing - Remove and Install” for more
information.
7. Tighten bolts (3).
This document has been printed from SPI². Not for Resale