Disassembly and assembly

40 KENR6226-01
Disassembly and Assembly Section
2. Remove two bolts (1) from positions (X) on the
flywheel.
3. Install Tooling (B) in positions (X) on the flywheel.
4. Remove the remaining bolts (1) and remove
flywheel (2).
Note: On some three cylinder engines, a roll pin is
located between the crankshaft and the flywheel.
5. Inspect ring gear (3) and flywheel (2) for wear or
damage. If the ring gear or the flywheel is worn or
damaged, use
new parts for replacement.
g00825639
Illustration 67
Typical example
6. To remove ring gear (3) from flywheel (2), place
the flywheel on a suitable support. Use a hammer
(not shown) and a punch (4) in order to remove
the ring gear from the flywheel.
i02645696
Flywheel - In stall
Installation P
rocedure
Table 10
Required Tools
Tool
Part
Number
Part Description
Qty
A
-
Lifting Bracket
1
B
-
Guide Stud
(M10 x 1.25 mm by
80mm)
2
NOTICE
Keep all parts clean from contaminants.
Contaminants
may cause rapid wear and shortened
component life.
Always wear pr
otective gloves when handling
parts that have been heated.
g01305341
Illustration 68
Typical exam
ple
1. If the ring gear was removed, follow Steps 1.a
through 1.c
in order to install ring gear (3) to
flywheel (2).
a. Identify th
e orientation of the new ring gear in
order to install the ring gear correctly onto the
flywheel.
Note: The chamfered side of gear teeth (Y) must
face toward the starting motor when the flywheel is
installed.
This will ensure the correct engagement of
the starting motor.
This document has been printed from SPI². Not for Resale